Anynone tested CNCing Soap ?

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC Anynone tested CNCing Soap ?

This topic contains 2 replies, has 3 voices, and was last updated by Profile photo of Ryan Ryan 3 weeks, 5 days ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #32698
    Profile photo of thesfreader
    thesfreader
    Participant

    Hi all,

    After many tests with wood (not completely successful since my non MPCNC lacks rigidity), I’ve have major success with polystyrene (Ahhh, so much easier with the soft material), but this morning, I had the idea to CNC soap. Is that a completely bad idea ? Did anyone try ? any tips ?

    #32707
    Profile photo of Jeffeb3
    Jeffeb3
    Participant

    I use liquid soap, so I think that would be a mess. 🙂

    #32713
    Profile photo of Ryan
    Ryan
    Keymaster

    It would work but HD foam is probably a better choice, unless you have some soap carving ideas.

    Clamping down a bar of soap is kind of impossible right?

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.