Australia 850W router option? (Oztivo)New Home › Forum › Mostly Printed CNC – MPCNC › Hardware Development – MPCNC › Australia 850W router option? (Oztivo)Tagged: oztivo, Router, SpindleThis topic contains 1 reply, has 2 voices, and was last updated by johan 4 months, 3 weeks ago.Viewing 2 posts - 1 through 2 (of 2 total)Author PostsOctober 2, 2016 at 12:21 am #18852 FermataParticipantI was going through bunnings today (as you do) And was looking possibly if they had the makita spindle/router there (they didn’t).but I did notice 2 routers, that I thought might do the job (and cheap), so i am wondering if anybody else (a) has one of them and/or (b). tried themThe first is a Trimer/router from Ryobi 400WFixed speed only, and only 400Wl, but very light and small.The second is a route from Oztivo 850WIt does support variable speed, and is 850W (about the same as a Kress 800 spindle option) as well as that 1/4 collet size.—Has anybody tried these on a MP-CNC, or should I pay the extra 300$ and go for s Kress instead?-FermataOctober 3, 2016 at 2:20 am #18904 johanParticipantI would get a kress, its an extremely good spindle. There is a reason pro’s use a kress.Author PostsViewing 2 posts - 1 through 2 (of 2 total)You must be logged in to reply to this topic.