Big giant map

New Home Forum LowRider Advice – LowRider Big giant map

This topic contains 2 replies, has 3 voices, and was last updated by  Barry 1 month ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #44197

    Ryan
    Keymaster

    Terrain, topological, waterline not sure what it would be called but I think this would be the craziest LowRider project.

    big

    Of course I am not going to run that for 11 hours but I wanted to see if it was even possible, looks like it is. I have a ton of settings to figure out and some samples to cut. Any ideas are welcome.

    I found this, http://jthatch.com/Terrain2STL/ Seems easy enough lots of settings to get right but unless you know of something better?

    I figure 4’x8′ HD foam spray glued to a 1/4″ ply sheet so I can hang it on the wall after some sort of paint coating.

    Need to cut some samples to see how thin I can go with the features still recognizable. I would prefer to only do one roughing/finishing pass all in one, foam is easy enough so as thick as my longest bit in one pass I hope.

    Attachments:
    #44200

    Jeffeb3
    Participant

    Wow. That would be intense.

    Why not just make it a lot smaller and then step closer?

    #44203

    Barry
    Participant
    Wow. That would be intense. Why not just make it a lot smaller and then step closer?

    Anybody could do that.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.