Bought a Kit from a Local maker but it has all the old parts

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC Bought a Kit from a Local maker but it has all the old parts

Tagged: ,

This topic contains 3 replies, has 3 voices, and was last updated by Profile photo of Barry Barry 1 month, 2 weeks ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #26755
    Profile photo of John
    John
    Participant

    Hello,

    The title kind of says it all. I only bought it off him because he had started it then decided that he didn’t want to build it. The “kit” I bought from him has all the old 3d printed parts. I know the new parts increase the rigidity of the cnc machine. How much improvement do I get by using the new parts. Do the new parts offer any improvements when it comes to aluminium or other hard materials?

    Thanks in advance,
    ~John

    #26757
    Profile photo of vicious1
    vicious1
    Keymaster

    Did You have another post? I just answered this about 10 minutes ago.

    Depends on how old your parts are. If they are the first ones I would stop and switch them now. Anything after that it depends on what you want to use the machine for.
    The upgrades increased rigidity, a lot, and made square assembly easier.

    #27132
    Profile photo of John
    John
    Participant

    @vicious1, Are there any parts for the middle assembly that I’m not going to have to reprint or was it a complete redesign as far as the parts went?

    #27133
    Profile photo of Barry
    Barry
    Participant

    Complete redesign. Tubes should still work through.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.