Built my MPCNC and now looking at the Low Rider

New Home Forum LowRider Advice – LowRider Built my MPCNC and now looking at the Low Rider

This topic contains 0 replies, has 1 voice, and was last updated by Profile photo of Wayne A Hogue Wayne A Hogue 2 months ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #33982
    Profile photo of Wayne A Hogue
    Wayne A Hogue
    Participant

    Very impressed with the MPCNC, deadly accurate with the pen effector (only one I have atm, Dewalt and Titan Areo in route)

    I am looking for a sheet cutter for a wikihouse.cc build. It call for +- .5mm accuracy on the cuts. These are all through cuts.

    Question, will I be able to achieve this accuracy consistently? Will need to cut up to 100 sheets for the project.

    TIA

    -Wayne

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.