Can not get steppers to step?

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Can not get steppers to step?

This topic contains 2 replies, has 2 voices, and was last updated by Profile photo of Glenn Glenn 2 months, 1 week ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #27829
    Profile photo of Glenn
    Glenn
    Participant

    Assembled machine, all the parts and controls from Vicious 1.

    Installed the Arduino software and ran the “Blink”. It blinked.

    Installed Repetier-Host, and completed the setup.

    Connected and tried to get the steppers moving to verify directions.

    No stepper movement and get message: communication timeout – reset send buffer block

    1) Did you buy everything from here? Yes

    2) Are you using end stops? Nope

    3) PC
    4) Include a picture so obvious errors might be spotted.

    #27833
    Profile photo of Ryan
    Ryan
    Keymaster

    If you bought it from me it was pre flashed with the firmware. If you flashed it with the blink code you have erased it. Now you need to put the firmware back on.

    Firmware

    #27835
    Profile photo of Glenn
    Glenn
    Participant

    Thanks, that worked!

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.