Can this zero and corner finder be used with mpcnc with repetier?

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC Can this zero and corner finder be used with mpcnc with repetier?

This topic contains 3 replies, has 3 voices, and was last updated by Profile photo of P3DCNC P3DCNC 4 months ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #28179
    Profile photo of Sorrentino
    Sorrentino
    Participant
    #28183
    Profile photo of Ryan
    Ryan
    Keymaster

    If you wrote a few custom scrips. But estlcam firmware can use it easily.

    #28184
    Profile photo of Sorrentino
    Sorrentino
    Participant

    Ok thanks, Ill give estlcam a try then.

    #28185
    Profile photo of P3DCNC
    P3DCNC
    Participant

    He shows the scripts you need to use on the instuctions of the link you posted. G38.2 commands. And apparently you need to use RC8.

    • This reply was modified 4 months ago by Profile photo of P3DCNC P3DCNC.
Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.