CNC Shield and Arduino UNO

This topic contains 1 reply, has 2 voices, and was last updated by Profile photo of Wesley Gardner Wesley Gardner 6 months, 1 week ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #20697
    Profile photo of Pietro

    Hi everybody, I’m assembling the wonderfull Mostly Printed CNC (Today I finished to print all pieces and in the week i will assemble the CNC). and I have a question for you:
    I have a CNC shield (like in the picture) with 4 A4988 deiver modules that I would use with Arduino UNO, is it compatible with Mostly Printed CNC? if yes can you help me with the firmware and how I must connect with the motor and with the softaeƬware?
    Thanks and bye bye

    Profile photo of Wesley Gardner
    Wesley Gardner

    Absolutely compatible just remember going this route you are going to be using more for cnc work not for 3d printing
    Firmware GRBL
    other then setting your settings shouldn’t be too hard.
    lots of info for setting up grbl

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.