Control board

This topic contains 2 replies, has 2 voices, and was last updated by Profile photo of Konstantin Borisov Konstantin Borisov 8 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #14951
    Profile photo of Konstantin Borisov
    Konstantin Borisov
    Participant

    I’m trying to build my own MPCNC. I’ve printed parts and assembled the mechanics. Now I’m trying to choose electronics.
    And here I have a problem. In Internet RAMPS boards are used mostly to control 3D printers. But I want to use my MPCNC for paper cutting and later 3d milling.
    RAMPS is very interesting because there is a SD card reader for it so I hope I’ll be able to do cutting without computer.
    Is there any software for RAMPS board to generate g-codes for 3d-milling and 2d-cutting? What control board should I buy for that?

    #14958
    Profile photo of vicious1
    vicious1
    Keymaster

    Ramps does it all very well.

    Have a look at the home page for the estlcam posts. It can do everything you want.

    #14962
    Profile photo of Konstantin Borisov
    Konstantin Borisov
    Participant

    Thank you very much!

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.