Cracked Z mount

This topic contains 3 replies, has 2 voices, and was last updated by Profile photo of vicious1 vicious1 10 months, 3 weeks ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #11967
    Profile photo of RAGII
    RAGII
    Participant

    The z mount was very tight on the conduit even without any screws in the assembly. Has I just started to engage the nylon insert in the nut the mount cracked. Any thoughts on repair or will it need to be replaced?

    Attachments:
    #11969
    Profile photo of vicious1
    vicious1
    Keymaster

    Should be fine, you can put a drop of superglue on it but there is not much of a load on that part.

    #11970
    Profile photo of RAGII
    RAGII
    Participant

    Thanks for the quick response. While I am waiting on the glue to dry I have a question on the coupler nut. I am assuming that if I do not use the spring in the system I leave the spring and the extra 5/16 nut off. Correct?

    #11971
    Profile photo of vicious1
    vicious1
    Keymaster

    Yes

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.