Drew\'s MPCNC Build

This topic contains 1 reply, has 2 voices, and was last updated by  Curt 1 year, 6 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #8589

    Drew Rogge
    Participant

    Here’s a video of my MPCNC plotting a version of Allted’s “vicious” logo. Was generated via Fusion 360 using the post processor from over on the Software->Fusion 360 forum.

    Video

    The path uses 2D adaptive clearing to optimize chip load.

    My machine is almost ready to make it out to the shop to make some dust 🙂 Just need to wire in the home/limit switches.

    Drew

    #8608

    Curt
    Participant

    Nice work! Welcome to the madness.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.