error

This topic contains 3 replies, has 4 voices, and was last updated by  Bill 3 weeks, 3 days ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #46450

    Martin Brandon
    Participant

    Tried to do a test print today but keep getting the following error. I don’t have a heated bed as i thought for pla you don’t need it. do I need to adjust something in the firmware and re flash it?

    https://drive.google.com/open?id=0B8WSK6YaVTHPWmhZc1k4WXlURm8

     

    Attachments:
    #46453

    John
    Participant

    Check the connection on your thermistor.  It’s either not plugged in, not mounted properly on the printer or faulty.  MINTEMP means that the board is not registering any temperature

    #46461

    Ryan
    Keymaster

    Yes you need to enable the thermistor in the firmware, the firmware for your board labeled with EB is for printing.

    Firmware

    The firmware is set from my mk8’s if you are using something else you will need to correct the thermistor value.

    #46742

    Bill
    Participant

    The error says it is the heat bed that’s not getting warm enough. You will have to disable the heat bed in the firmware in order to get it to work.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.