Estlcam questions

This topic contains 3 replies, has 2 voices, and was last updated by Profile photo of Zeenon Zeenon 1 month, 1 week ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #27198
    Profile photo of Zeenon
    Zeenon
    Participant

    I’ve been playing around with estlcam 10 and trying to figure out how to successfully carve out a picture like the below. Basically, I want the inside cut out and all the islands inside flush with the top of the wood, similar to if you were to use a fill tool – everything that is filled inside I want to discard. I use the hole tool to highlight the outer edge, then it my lack of knowledge kicks in, because I’m not sure of of what to select, so it becomes a big mess of pockets and islands.

    Pirate Ship

    Z

    Attachments:
    #27202
    Profile photo of Barry
    Barry
    Participant

    Make all the inside pieces outside cuts, then select the outside line and make it an inside cut with islands.

    #27298
    Profile photo of Zeenon
    Zeenon
    Participant

    Barry,

    Many thanks!!! That is exactly what I wanted to do, just needed a little guidance.

    On a side note, when using the engraving tool on the same picture, is there a way to do a mass selection or do you need to click on each small piece?

    Pirate ship printed

    #27432
    Profile photo of Zeenon
    Zeenon
    Participant

    Guess it’s time to stop screwing around and get a 660?

    pen images

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.