extruder cable pinout

This topic contains 3 replies, has 2 voices, and was last updated by Profile photo of vicious1 vicious1 1 month ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #27603
    Profile photo of Jon Petersen
    Jon Petersen
    Participant

    I’m troubleshooting the skip/missing filament in my prints. Have watched the gear turning, and have noticed that the skips occur when the gear is not turning. Was wondering if my cable extension wiring job did not work, so I’m about to rebuild it. At the same time I was going to add some LED’s so I can see when that motor is getting voltage command.

    Does anyone have a pin-out for the cable?

    #27605
    Profile photo of vicious1
    vicious1
    Keymaster

    I just answered your other post, pretty sure that was is the issue.

    #27606
    Profile photo of Jon Petersen
    Jon Petersen
    Participant

    I’m still rebuilding the extension. Do you have a pinout?

    #27607
    Profile photo of vicious1
    vicious1
    Keymaster

    It’s a standard stepper 2 pairs of coils. You can get the coils by feel or multimeter. The ramps board is in order pair 1 ab pair 2 cd. You might want to tackle 1 issue at a time.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.