Extruder Motor Not Moving

This topic contains 2 replies, has 2 voices, and was last updated by Profile photo of Jacob Jacob 1 year ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #8739
    Profile photo of Jacob
    Jacob
    Participant

    I have my extruder motor plugged into E0. It will not manually feed filament or feed when i try to print when it is hot or cold. The motor will move when I plug it into the pins for the X or Y steppers. I’m using an MK8 extruder from ebay, and everything else from here.

    #8747
    Profile photo of nerdyrcdriver
    nerdyrcdriver
    Participant

    I know this sounds obvious, but do you have a stepper driver for the extruder on the board?

    If there is, is it in the correct orientation? Any idea what the current limit is set at?

    #8752
    Profile photo of Jacob
    Jacob
    Participant

    Yep, that was it. I need a stepper driver. Thanks!

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.