Filament pause switch

This topic contains 2 replies, has 3 voices, and was last updated by Profile photo of Remailednet Remailednet 1 week, 2 days ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #29522
    Profile photo of Mmmfishtacos
    Mmmfishtacos
    Participant

    Anyone have Ideas on how to make one?

    I’m using half rolls and I’m afraid to run out during a print.

    #29562
    Profile photo of Barry
    Barry
    Participant

    Open up your configuration.h and do a search for filament, it’s in there. Add one of these and some wires and it should work, if you print from the lcd! I think it’s servo3 pin. Not sure if this works, but that’s what I found.

    #36241
    Profile photo of Remailednet
    Remailednet
    Participant

    https://cults3d.com/en/tool/filament-tracking-system

    I’ve made these for my printers. They all run repetier fw though.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.