Fix: The Device Cannot Start (code 10)

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Fix: The Device Cannot Start (code 10)

This topic contains 2 replies, has 2 voices, and was last updated by  James 1 year, 8 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #7142

    James
    Participant

    I fought with this for a couple hours this evening when I was trying to finally get the Arduino plugged in.
    Hope this helps anyone else who has the same problem in the future.

    #7252

    Ryan
    Keymaster

    Did this happen with my board or did you get your own?

    #7274

    James
    Participant

    It was from your kit. I didn’t check it to see if it was real or a knockoff, frankly I couldn’t care less. It works now, that’s all I care about.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.