Flashing Ramps 1.4 guide

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC Flashing Ramps 1.4 guide

This topic contains 2 replies, has 3 voices, and was last updated by  Ryan 4 months, 2 weeks ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #37215

    Martin Brandon
    Participant

    Just wondering if anyone has a guide or better still could walk me through flashing the firmware onto a ramps setup? Where do i get the power for the board from? Do I plug the round connector from my supply into the round connector on the mega 2560 to supply it with power while flashing? obviously i know that it needs connecting to my computer via usb.

    #37216

    BT
    Participant

    You should only need to connect the mega 2560 to your computer using the USB cable – no other power is needed. Arduino.org has a pretty good set of instructions on how to do it, the basic steps are listed at Getting Started which has some links on how to install the IDE for Windows and Mac as well as the links to board specific instructions.

    #37222

    Ryan
    Keymaster

    Step by step with pictures.

    Firmware

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.