G-Code xyz 0 setup

This topic contains 3 replies, has 3 voices, and was last updated by Profile photo of P3DCNC P3DCNC 3 months, 1 week ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #27070
    Profile photo of AL
    AL
    Participant

    Hello!
    I am trying to setup the XYZ 0 for the piece that I am trying to cut.
    It looks like the only way to set my ZERO point is by shooting down and powering up the machine. Otherwise it recognizes only the last ZERO point that was setup.
    I tried to issue a G92X0Y0Z0 from the Repetier Host with negative results.
    Does anyone have this problem?
    Any tip how can I solve this??
    Thank you!

    #27071
    Profile photo of Ryan
    Ryan
    Keymaster

    I reset the arduino, but if you don’t want to do that. Try a a space after the G92 X0 Y0 Z0

    #27072
    Profile photo of AL
    AL
    Participant

    Thank you!
    Yes it works!

    #27126
    Profile photo of P3DCNC
    P3DCNC
    Participant

    In addition, on the PC Repetier you can type the code in upper or lower case. On a MAC, it doesn’t recognize lower case. FYI.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.