Inventables Quiet Cut Spindle?

New Home Forum Mostly Printed CNC – MPCNC Hardware Development – MPCNC Inventables Quiet Cut Spindle?

This topic contains 4 replies, has 5 voices, and was last updated by  P3DCNC 7 months, 2 weeks ago.

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #20719

    Mike B
    Participant

    has anyone tried using the inventables Quiet Cut Spindle?

    Quiet Cut Spindle

    I know the dewalt dw660 is highly suggested on here… but looking for a good spindle that isn’t as noisy

    suggestions?

    #20720

    Brian
    Participant

    I’m looking very hard at that as well. I have the dewalt already (actually used it as intended lol). But it is very loud. This should be a good compromise between noise and function for me.

    #20732

    Barry
    Participant

    I should be getting one next month.

    #26566

    Olle Eriksson
    Participant

    Hi guys,

    I’m in the same spot that you guys were 2 months ago. Living in a flat so thinking the quiet cut spindle could be a good compromise between noise and functionality. Did any of you go ahead with the quiet cut spindle and have a success story to report?

    Cheers

    #26570

    P3DCNC
    Participant

    I’m also very interested in a quieter spindle. It would be great if you could turn it on and off with the RAMPS setup. Or would you have to go to another controller setup?
    How would you wire a 48V spindle like this one?
    Could you combine it with something like the super-PID for the ultimate setup?
    Or better yet, have the spindle set itself to the rpms your set up in your gcode (tool selection is ESTLCAM or Fusion 360?

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.