Laser and Router

This topic contains 2 replies, has 2 voices, and was last updated by  Zach K. 1 year, 3 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #13258

    Zach K.
    Participant

    Hi I have been running my mpcnc a bunch with the router and im just wondering how easy it is to switch between the laser and the router. I do not have the laser built yet.

    #13263

    Ryan
    Keymaster

    You can just stick the Laser on your tool and run it a bit slower, or take the tool off to lighten the load and run it a bit faster.

    #13266

    Zach K.
    Participant

    Alright thanks I plan on getting one built in the next week or so

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.