LCD question!

This topic contains 3 replies, has 2 voices, and was last updated by  Marc Suggs 3 weeks, 5 days ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #44628

    Marc Suggs
    Participant

    OK So I have been making some successful cuts over the past week or so. (or at least i think they look good) anyway – I finally decided to hook up my LCD to the mini rambo. It can move the machine around just fine (haven’t tried to mesure yet to make sure it is moving the right length but seems pretty close so far). Steps I take so far are to design what I want in inkscape(well mostly inkscape) then move it to ESTLCAM for tool paths and gcode then repetier host for cutting.

    Now I followed the same first two steps but instead of opening up the *****.nc in repetier host I saved it to the sd card and took that to the lcd and inserted it but the file is nowhere to be found.

    I verified it was on the SD Card but the lcd wont show it.

    Am I missing something? is there some setting the needs to be changed or activated along the way or the mini rambo. I’m sure its simple but not for this newbie…

     

    Thanks in advance for any info….

    #44629

    Ryan
    Keymaster

    Re-name it to *.gcode.

    #44630

    Ryan
    Keymaster

    You can make it automatic here.

    1 user thanked author for this post.
    #44631

    Marc Suggs
    Participant

    Thanks for the quick response.  That worked great.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.