LCD Screen

This topic contains 2 replies, has 3 voices, and was last updated by Profile photo of Ryan Ryan 1 month, 1 week ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
  • #33817
    Profile photo of Nathan Ickes
    Nathan Ickes

    Hi i bought the MPCNC kit about 2 weeks ago. I built it and wired it all up after following your instructions and the ramps board you sent me doesnt work because i see 2 bars on my lcd screen. you said you already put in the software in the board so i dont want to mess with the marlin settings. where do i go from here?

    Profile photo of David Walling
    David Walling

    Can you post a picture of the back of the LCD display?

    Make sure the cables are going in the right spots.

    There should also be a small POT on the back of the LCD for adjusting the contrast of the LCD. You can try adjusting that.

    Profile photo of Ryan

    That is not the screen the board is flashed for, you will need to change the firmware.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.