Maximum SizeNew Home › Forum › Mostly Printed CNC – MPCNC › Advice – MPCNC › Maximum SizeThis topic contains 1 reply, has 2 voices, and was last updated by Ryan 1 month ago.Viewing 2 posts - 1 through 2 (of 2 total)Author PostsApril 25, 2017 at 9:10 am #32179 ProjectParticipantHi,I think this may have been asked before. I am thinking of building a MPCNC slightly bigger than 4′ x 4′ The reason is because I wish to load a full piece of plywood into the machine.But I do not want to sacrafice on accuracy too much. Will a 4′ x 4′ machine be rigid/accurate? Or am I better off building two machines (aka low rider). I see there are support mounts for the MPCNC.April 25, 2017 at 9:12 am #32180 RyanKeymasterGo with the LowRider, that is what is was built for.Author PostsViewing 2 posts - 1 through 2 (of 2 total)You must be logged in to reply to this topic.