Maximum Wheel Size ?

New Home Forum LowRider Advice – LowRider Maximum Wheel Size ?

This topic contains 3 replies, has 2 voices, and was last updated by  Ryan 6 months, 2 weeks ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #30602

    Sebastien Plante
    Participant

    Hello,

    First post here. I’m planning to build a CNC for a while, I want to begin small (about 24×24 inch (610mm) working area) to begin with and I wish to keep the cost as low as possible (and upgrable if possible). This build is awsome, since I have eveything in stock, except the wheels, bearings, GT2_16T (But I think I got some 20T, maybe I can use them and update the firmware?), steel tube and some wood for the frame, so the starting cost is very low !

    So, to the question :
    80mm rollersblade wheels seems more common where I live, is this too big ? I guess it is, looking at the bearings that are near them, but it’s hard to say.

    #30609

    Ryan
    Keymaster

    16t provide more torque, if I remember right 20%. 20T will work though.

    You’re looking for hockey wheels. The bigger ones will work but you will need to compensate by using a thicker spoil board and a thinner table. I do have the wheels in the shop.

    #30612

    Sebastien Plante
    Participant

    cool thanks!

    I might orders from your store (mosty to encourage you and your design), but I’m in Canada, is this okay?

    #30619

    Ryan
    Keymaster

    I ship world wide.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.