more info on next steps?

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC more info on next steps?

This topic contains 2 replies, has 2 voices, and was last updated by Profile photo of Ryan Ryan 2 weeks, 4 days ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #35299
    Profile photo of Ryan
    Ryan
    Participant

    I’ve installed firmware, I see it boot in Arduino’s serial monitor.
    I’ve installed estlcam.
    I was getting an error saying unable to control cnc.
    I flashed Arduino with estlecam firmware 10.001
    now it says active.
    and when I go to CNC controller, I don’t get an error, but I get no action from motor (I have just x hooked up now.)

    not sure how to trouble shoot ramps.

    Arduino seems to be working.

    Thank you!

    also, wire management? solutions?

    • This topic was modified 2 weeks, 4 days ago by Profile photo of Ryan Ryan.
    #35304
    Profile photo of Ryan
    Ryan
    Keymaster

    Let’s get you rolling.

    Start here, https://www.vicious1.com/assembly/software/

    Do not use ESTLCAM to control your machine, at least not at this point until you have a strong reason to do so. Estlcam is only to generate your gcode file, that is it.

    • This reply was modified 2 weeks, 4 days ago by Profile photo of Ryan Ryan.
    #35311
    Profile photo of Ryan
    Ryan
    Participant

    thank you!
    hopefully I have good news to report.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.