MPCNC and CURA

This topic contains 4 replies, has 3 voices, and was last updated by  Bill 8 months, 3 weeks ago.

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #28255

    Ralph
    Participant

    Hi

    Is it possible to use CURA for a slicing option with the MPCNC? I have a 3D print design that recommends CURA instead of Sli3er. If so does any have settings for it?

    Thanks r.

    #28278

    Ryan
    Keymaster

    Yes, any slicer.

    #28485

    Ralph
    Participant

    Thanks. Does anyone have example settings for CURA with MPCNC?

    #28492

    Ryan
    Keymaster

    You can use the settings shown in the import extruder setup page, they will just be in different places in cura vs slic3r.

    #28533

    Bill
    Participant

    I just tried Cura in Repetier-Host on my MP3DP today with the default settings. Boy! I had forgotten how much I’d dialed things down in Sli3r… 🙂 It was moving in a blur.

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.