Multimeter

This topic contains 3 replies, has 4 voices, and was last updated by Profile photo of Jeffeb3 Jeffeb3 1 week, 5 days ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #38083
    Profile photo of Martin Brandon
    Martin Brandon
    Participant

    This is my multimeter, am about to adjust the vref on my 8825 drivers.

    Have I set it correctly for reading less than 2volts

    Could someone confirm for me please? If it’s wrong could you tell me which setting it should be on

    IMG_20170712_175434

    #38087
    Profile photo of Ryan
    Ryan
    Keymaster

    That should do it.

    #38090
    Profile photo of Jakob A
    Jakob A
    Participant

    isn’t 200mV only 0.2 V ? I would think you need the 2000mV setting.

    #38102
    Profile photo of Jeffeb3
    Jeffeb3
    Participant
    isn’t 200mV only 0.2 V ? I would think you need the 2000mV setting.

    Yep. I concur.

    You have the leads in the right place, that’s the most important part. Just try to be extra steady with those leads. If you don’t short something, you’ll do fine.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.