My Build

Tagged: ,

This topic contains 2 replies, has 1 voice, and was last updated by Profile photo of Kevin Kevin 11 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #10952
    Profile photo of Kevin
    Kevin
    Participant

    So after getting the conduit squared away(tubing cutter is worth the small price).; I continued with the printing of the pieces.
    I got the middle part together and I am amazed at the genius behind it. Ryan you are a true genius.

    Sp far the only piece that was really difficult was of course the Rigid-Z. I got it printed twice but if you look at the assembled parts you’ll see a piece of duct tape. That duct tape is holding down a little piece of plastic that was coming up. I don’t think it affects anything and I’m hoping the Gorilla Glue holds it so I don’t have to print that piece again.
    Hopefully I’ll have the rest of the parts printed by this weekend about 36 hours more to go.Over the weekend I hope to tackle the table

    #11185
    Profile photo of Kevin
    Kevin
    Participant

    Finished printing and assembling most of parts. I decided to reprint one of the rigid z which came out better this time. Today it’s time to build the table. Cut the wood yesterday.

    #11308
    Profile photo of Kevin
    Kevin
    Participant

    Table top frame , ready for legs and top

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.