Need some advice for the print quality

New Home Forum don’t use this one, I need to sort and delete -Troubleshooting Need some advice for the print quality

This topic contains 1 reply, has 2 voices, and was last updated by Profile photo of vicious1 vicious1 1 year ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #9767
    Profile photo of Apach
    Apach
    Participant

    Hello, i do many test to improve the quality for the 3D print of my MPCNC.
    I begin to be happy with the results and i don’t know if i can do it better or if i’m limited by the MPCNC.
    This is a comparison picture of the result from a makerbot replicator 2 who cost 2899$, and at the right the result from MPCN.

    MPCNC

    I think the result is pretty cool, but can i improve it more ?
    I think the most important problem is the rounded edge i have with MPCNC, do you have some tips for correct it ?
    In this picture, i use the exact same settings than Vicious in the tutorial for Repetier here : https://www.vicious1.com/import-extruder/
    Just the layer height is 0,2 mm for the both.

    Thanks a lot for your help !

    Attachments:
    #9770
    Profile photo of vicious1
    vicious1
    Keymaster

    Two things I see right off the bat you might be extruding a little too hot, and/or your print fan needs some help.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.