New Use for MPCNC.. engraver

New Home Forum Mostly Printed CNC – MPCNC Hardware Development – MPCNC New Use for MPCNC.. engraver

This topic contains 2 replies, has 2 voices, and was last updated by  Autox3D 8 months, 2 weeks ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #28939

    Autox3D
    Participant

    Building a 4×4 footer with a engraving pen on it. sheet metal layouts.. 🙂

    #28945

    Ryan
    Keymaster

    What does that mean? You engrave the pattern on metal to cut by hand? Fold/bend lines?

    I am very intrigued by a new function!

    #29003

    Autox3D
    Participant

    Ok, Ill break it down.

    I built a 4×4 foot Open Builds CNC plasma table 15 months ago. It has been used but it was found to be limiting because they still had to scribe and manually measure bend lines.

    The shop builds rice mills, Good stuff but still 90% of the work is done old school, punching, shearing and press brake. The steel is too thick for the normal auto body nibbler tools.

    Awhile back the guy who does layouts for everyone else to work started acting like a jerk and slowing down things. Something has to be done. Its a precision job and takes a lot of practice.

    We were toying with adding a engraving pen to the plasma, but then we had a inspiration to just use a MPCNC with a engraving pen on it as a stand alone machine. Basically it is a plotter that uses a engraving pen instead of a marker. Markers tend to smudge and have a thick line vs the little engraving pens.

    The plan is the layout to be exported to dxf, then estl cam and scribe the cut lines/bend lines on the sheet metal and shear/bend/punch it.

    We are also using mach3 for this build as the complete board is only $28 from China thru the mail.

    It is still a bit of a experiment project as we are also looking at a pissible re-design to bushings vs the roller bearings to lower parts count.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.