No control from computer to mpcnc

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC No control from computer to mpcnc

This topic contains 2 replies, has 2 voices, and was last updated by  John Hieber 1 month, 2 weeks ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #37407

    John Hieber
    Participant

    I can run commands from a sd card, but not via usb. this is most irksum when using repetier host.

    I bought the hardware Kit from the vicious1 website,

    I updated the firmware using the guide (so i no longer need the resistor)

    im using win xp (pc)

    the usb2.0-serial driver (com5) was set to 9600 baud, I upped it to 128000

     

    the repetier host was at 256000 i lowered it to 128000, (the program also will stop the card from printing if the program starts mid print up mid print.

    I would like to print/mill/plot from repetier host but right now its not responding, any time i do manual controls it builds up as (X#) command waiting.

    repetiers log is saying “communication time out, reset send buffer block”

    anytime i hit print, the printer doesnt move but repetier looks like its trying to do something

     

    #37424

    Barry
    Participant

    Pretty sure the arduino is using 250000 for the baud rate. Β It’s what mine are set to anyway.

    #40142

    John Hieber
    Participant

    I got it Running, thanks Barry

     

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.