Nut Trap for 25mm OD 2mm StainlessSteelTube and which NutHolder to use

New Home Forum don’t use this one need to sort -Assembly – MPCNC Nut Trap for 25mm OD 2mm StainlessSteelTube and which NutHolder to use

This topic contains 4 replies, has 2 voices, and was last updated by Profile photo of Markus Hauser Markus Hauser 7 months, 1 week ago.

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #16376
    Profile photo of Markus Hauser
    Markus Hauser
    Participant

    Hi!
    Which Version of the Nut traps fit best for 25mm OD 2mm Wall stainless Steel tube? and which version of the nut holder (M8 25mm couplernut) to be used?
    Thx

    #16380
    Profile photo of vicious1
    vicious1
    Keymaster

    That is thick tube, you are going to have to sand them down or cut off the edges. No big deal.

    #16381
    Profile photo of Markus Hauser
    Markus Hauser
    Participant

    ok. got it. Which version for the nut lock? 11mm or 13mm? where to measure?

    #16382
    Profile photo of vicious1
    vicious1
    Keymaster

    The nut locks are for the coupling nut, flat to flat measurement. Shown here, https://www.vicious1.com/assembly/middle/

    #16393
    Profile photo of Markus Hauser
    Markus Hauser
    Participant

    Thank you very much for your great design and especially releasing it to the public. Will measure the nut when i have mine on hand… Still on shippment.

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.