Old part request

This topic contains 1 reply, has 2 voices, and was last updated by Profile photo of vicious1 vicious1 2 weeks ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #29645
    Profile photo of John
    John
    Participant

    I need to reprint a couple of the part that holds the pipes down for X / Y in my MPCNC… but, I can’t find them. it was a flat-ish part using leverage and 2 screws to hold in place.

    also… are the new rollers enough better to bite that off instead of just reprinting the piece that’s broke?

    #29647
    Profile photo of vicious1
    vicious1
    Keymaster

    Picture?

    Yes the new rollers pretty much eliminate the motor mount flex, much more rigid.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.