Oregon dish

New Home Forum Things You Have Made Oregon dish

This topic contains 4 replies, has 3 voices, and was last updated by Profile photo of Nate Nate 2 weeks ago.

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #37269
    Profile photo of Nate
    Nate
    Participant

    So this is my first 3d cut, I had some chatter issues at anything under full speed on the Makita router but I think that has more to do with a dull bit than anything else(had a failed cut that overheated and wedged/extracted the bit).

    The final pictures are without any finishing other than cutting off the holding tabs, what do you all think? I’m surprised to have such limited machining marks, I really thought my machine would need more tweaking to get results like this.

    IMG_20170701_142805
    IMG_20170701_165321
    IMG_20170701_170312
    IMG_20170701_170521
    IMG_20170701_195257
    IMG_20170701_195243
    IMG_20170701_195140
    IMG_20170701_195157

    Cheers,

    Nate

     

    #37279
    Profile photo of Ryan
    Ryan
    Keymaster

    Dang you did all of that with that short little bit? That is impressive!

     

    Gallery for sure.

    #37292
    Profile photo of Nate
    Nate
    Participant
    Dang you did all of that with that short little bit? That is impressive! Gallery for sure.

    It was about a .5mm of clearance to the collet, cutting it really close on that one. I’ll definitely be getting some longer bits.

    #37366
    Profile photo of Dan
    Dan
    Participant

    Looks great! Are you in Oregon? I’m in Salem.

    #37736
    Profile photo of Nate
    Nate
    Participant
    Looks great! Are you in Oregon? I’m in Salem.

    Thank you!

    I lived in Portland for a few years and met my lovely partner there, she is from Newberg.

    We reside in Knoxville, Tn now.

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.