Original stl files?

This topic contains 6 replies, has 2 voices, and was last updated by  Ryan 1 week, 2 days ago.

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • #43507

    mike
    Participant

    Are the original stl files still available anywhere?  My Z motor mount broke and I’d like to reprint but that hard drive and file is long gone.  I’m sure the new one is better but I’d just like to fix it quick.

    #43508

    Ryan
    Keymaster

    There has been a few. You need to put up a picture and the size of your conduit.

    #43510

    mike
    Participant

    23.5mm I believe.  Here is a pic of what’s left.

    #43529

    Ryan
    Keymaster

    I think this is it.

    • This reply was modified 1 week, 3 days ago by  Ryan.
    #43572

    mike
    Participant

    That looks like it.  I’ll give it a try.  Thanks!

    #43584

    mike
    Participant

    Yep, That was it.  Question, to switch to the new version, do I have to remake the whole center section?  And is it complicated to switch from the rod to a leadscrew?

    #43592

    Ryan
    Keymaster

    To switch the entire center has to be made at once. All the parts are matched. And the new rollers really are a pretty solid upgrade as well. If you are switching to the new stuff switching to the T8 it will be no big deal, t8, nut, new firmware.

Viewing 7 posts - 1 through 7 (of 7 total)

You must be logged in to reply to this topic.