Project ideas

New Home Forum Things You Have Made Project ideas

This topic contains 1 reply, has 1 voice, and was last updated by  Peter A Mills 3 months, 1 week ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #35879

    Peter A Mills
    Participant

    I found another website with some cool projects. Perhaps this could be a repository for where to find projects? Here’s one I just found:

    https://www.inventables.com/projects

    Seems to be supporting their carving machine, but there’s lots of ideas and a forum with some good discussion.

    #35919

    Peter A Mills
    Participant

    I’ve been poking around this site and Inventables also has an all-in-one design and CAM program called Easel. It looks pretty user friendly but it’s setup primarily for their machine. I’m not sure the flavor of G-Code it outputs would be compatible with Marlin in the MPCNC. Can someone with more knowledge take a look?

    https://inventables.desk.com/customer/en/portal/articles/2258567-easel-g-code-spec

    It does look like it’s fairly locked down in order to make it easier to have a successful project.

    Also, no tool changes, which is pretty constraining.

    OH, as I’m typing this I’m still looking through their forum. There’s some crossover already as a topic mentions doing just this:

    https://discuss.inventables.com/t/easel-and-ramps-marlin/17033/23

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.