Repetier firmware instead of marlin

New Home Forum Software Development Repetier firmware instead of marlin

This topic contains 2 replies, has 2 voices, and was last updated by  punkti 1 year, 8 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
  • #5948


    I dont know if someone have tried allready to use the repetier firmware, but i really would like to use it.i have it running on my delta printer and especially the eprom usage directly from repetier host and server is super usefull.

    As far as i saw marlin has just some minor tweaks from alted … So it should be possible. Any suggestions or something i should be aware? My electronics are just on the way so i can not start testing jet…by the time i can i will upload my config..



    I listed everything but the pin change for the lcd. should be easy.



    so as i expected…

    i am waiting to get my electronics… so after i have everything together i will start with that..


Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.