Robo Question

New Home Forum Random or Off Topic Robo Question

This topic contains 3 replies, has 2 voices, and was last updated by  Ryan 3 months, 1 week ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #35814

    David
    Participant

    I have a Robo R1+ I used to print my MPCNC. It appears I have a bad ramps board or Arduino. Can I use any RAMPS 1.4 clone and flash it with Robo firmware? Any boards in particular to look for or avoid? I replaced the stepper driver and set it but nothing. all other axis are working and if I move the Extruder (the offending axis) to another axis it works. I know my voltage is good as I had them previously mapped. I thought I would ping the board since I know some of us started on a Robo. Thanks.

    Dave lively
    Tampa

    #35819

    Ryan
    Keymaster

    You might be able to just remap your extruder to port E1 instead of E0.

    #35826

    David
    Participant

    Dooode! I did not think of that! How simple! I’ll give it a try tonight. I’ve consumed a bunch of info since I posted and I may still buy a generic some guys are using in the Robo board but perhaps it may just become a backup. Thanks Ryan.

    #35828

    Ryan
    Keymaster

    Any board will work in the R1, if that doesn’t fix it. Most any printer can have a board swap relatively painlessly.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.