Some signs

New Home Forum Things You Have Made Some signs

This topic contains 6 replies, has 5 voices, and was last updated by  Karel 1 month ago.

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • #45984

    Dan
    Participant

    I think this is the best quality sign I have made with the mpcnc. Getting a quality v hit made all the difference.  The picture doesn’t do it justice.  I will post a picture of the painted sign when it is done.

    2 users thanked author for this post.
    #45986

    Dan
    Participant

    I only did the bottom sign in this picture.  It was an add on for a friend,  trying to match the original sign.

    1 user thanked author for this post.
    #45988

    Pinhas Gold
    Participant

    They are both awesome

    1 user thanked author for this post.
    #46014

    Neil
    Participant

    Looks great!! Which bit did you use for the h these?

    Neil

    #46015

    Dan
    Participant
    Looks great!! Which bit did you use for the h these? Neil

    I used a Whiteside 60 degree 1/4″ inch v groove bit for the Harley sign.  For the other sign I used a cheap harbor freight bit, and I would not recommend it. I love the whiteside bit though.  I’m glad I practiced with cheap bits, but wish i would have switched to this sooner! I think it was only $14 on Amazon,  so not bad costwize.

    #46052

    Johnny
    Participant

    That Harley sign is sexy Dan. Well done. Can’t wait to see it painted.

    1 user thanked author for this post.
    #46091

    Karel
    Participant

    Wow these are great Dan! Thx for the info on the bit you used.

Viewing 7 posts - 1 through 7 (of 7 total)

You must be logged in to reply to this topic.