sucess at last.

This topic contains 6 replies, has 4 voices, and was last updated by  Fingerss 5 months, 3 weeks ago.

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • #28092

    Fingerss
    Participant

    I finally get to celebrate a successful run with no communication failures, dimensional mismatches, or skipped steps. Thanks to all that helped me get my bugs worked out.

    Attachments:
    #28096

    Jeffeb3
    Participant

    That’s really neat looking. What project is that?

    #28098

    P3DCNC
    Participant

    Cool and congrats! Time for dust collection eh :)?

    #28099

    Fingerss
    Participant

    Since Recreational smoking has become legal in CA. I have had a request for a rolling station. I could have done it all on the router table but this way is much faster and safer. I’m repurposing an old butcherblock desk that someone gave me. I’m going to use my MPCNC to finish up the pendulum clock in the background. I have one gear that is VERY difficult to cut by hand.

    #28100

    Fingerss
    Participant

    I have dust collection just didn’t use it because I was tracking down possible EMI issues. I will be in the future. I’m fortunate to have a pretty well stocked wood shop. More so now than ever.

    #28129

    Bryan
    Participant

    That is really clean. Where the heck is your wiring?

    #28154

    Fingerss
    Participant

    Bryan,
    X and Y run thru the tubes and over the edge of the table. I have a box mounted to the underside of the table vented and cooled with the electronics in it. I do discrete wiring inspection for a living and know some tricks. Everything is on a 2.5″ thick roll around table.

Viewing 7 posts - 1 through 7 (of 7 total)

You must be logged in to reply to this topic.