Temperature not transfering when slicing/printing files

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC Temperature not transfering when slicing/printing files

This topic contains 2 replies, has 2 voices, and was last updated by Profile photo of Rand Rand 3 weeks, 2 days ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #32965
    Profile photo of Rand
    Rand
    Participant

    I have been putting up with this problem for months,,, When I slice a part and send it thru my pc to print about half the times it transfers without the extruder temperature. It shows 0 on the attached screen and just lets the temperature drop. The heated bed works perfectly. I can control the temperature of the extruder in the manual mode and from the temperature CONTROL selection small screen on the machine. If I load the same file again it might work perfectly.. Any ideas?

    I am running MPCNC stock from Ryan – Marlin, Ramps, Repetier test file.
    Standard hot end extruder and no end stops.

    Any help would be appreciated.
    Rand

    #32966
    Profile photo of Ryan
    Ryan
    Keymaster

    It could be a usb issue, I would save the gcode onto your SD card, then run the file from the screen. Less chance for errors that way.

    #32976
    Profile photo of Rand
    Rand
    Participant

    Thanks Ryan,
    I have to get a SD card and give that a try. I found if I select MANUAL and select 220 degrees to preheat the extruder then slice the part and select print it works. I don’t know if there is a connection.

    I reprinted the Z axis parts (new style) and replaced the roller to the new design. It eliminated the slant problem I was having and was able to get that axis to be straight up and down.

    Thanks for your help.
    Rand

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.