Tip for installing gantry

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Tip for installing gantry

This topic contains 1 reply, has 2 voices, and was last updated by  Walter 1 year, 8 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #7806

    Drew Rogge
    Participant

    This may have been obvious to other folks but I figured out after my gantry was installed that the correct way of getting the gantry tubes into the Roller_F’s is to slide the conduit through the motor mounts. I did it the hard way by bashing the conduit between the Roller_F and the Roller Lock. It’s amazing the both parts stood up to such abuse 🙂

    Drew

    #7816

    Walter
    Participant

    ;(

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.