Tips for laser

This topic contains 4 replies, has 4 voices, and was last updated by Profile photo of Mike Carr Mike Carr 1 month, 3 weeks ago.

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #33518
    Profile photo of Nick Vandevelde
    Nick Vandevelde
    Participant

    I’m searching for a laser kit able to engrave on wooden surfaces, and cutting thin wood, plastic ect…, to mount on the mpcnc i’m currently printing.
    The kits I’ve found on http://jtechphotonics.com/ ar quite expensive.
    Any tips or links to perhaps some more budget friendly kits? (something around 120 euro?) compatible with this mpcnc?

    #33527
    Profile photo of Ryan
    Ryan
    Keymaster
    #33628
    Profile photo of Nick Vandevelde
    Nick Vandevelde
    Participant

    Thx for the reply, I’ve allready looked in DTR’s shop, but I can’t find the assembled module as shown in the pdf. Perhaps no longer available?

    #33679
    Profile photo of Dennis Wright
    Dennis Wright
    Participant

    I ordered an NDB7875 9mm 445nm via Amazon sold by DTR on 6 May and delivered last week from St Louis MO 63141. It was described on the customs declaration as “salvage dip projector parts” and is a “gift”. I am in the UK. Got to wait till June for Banggood to deliver the laser drivers so I have no idea if it works!

    Dennis

    #34832
    Profile photo of Mike Carr
    Mike Carr
    Participant

    I bought this one http://www.ebay.com/itm/172235645052?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
    , seems to work perfectly but I am new to all this and still learning. With that said, any recommendations for safety goggles? Not sure if the $20 are safe enough.

    UPDATE: LOL, just realized mine is 1.4W, now I need to check out the 2.8W

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.