Top and bottom of prints getting cut off

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Top and bottom of prints getting cut off

This topic contains 3 replies, has 3 voices, and was last updated by Profile photo of Dan Dan 1 month, 1 week ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #35568
    Profile photo of Dan
    Dan
    Participant

    I have had the problem of the top and bottom of my engravings getting cut off. I am using Fusion 360 to generate the gcode and sending the gcode to my MPCNC with Repettier host via USB. When I look at the simulations they appear correct. Any thoughts on how to debug this?

    Thanks!

    #35573
    Profile photo of Ryan
    Ryan
    Keymaster

    That seems odd. Laser or milling?

    #35577
    Profile photo of Jeffeb3
    Jeffeb3
    Participant

    Top and bottom how? Like a min and max X?

    #35601
    Profile photo of Dan
    Dan
    Participant

    I checked the simulation again, and it is actually doing it exactly right (matching the simulation), so I must be doing something wrong in Fusion 360.I was using 3D pocket clearing, and it didn’t seem to capture the frame I made around the top and bottom border.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.