Troubles with the Z axis bearings

New Home Forum Mostly Printed 3D Printer -MP3DP Troubleshooting – MP3DP Troubles with the Z axis bearings

This topic contains 1 reply, has 2 voices, and was last updated by  Ryan 1 week, 5 days ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #45750

    thesfreader
    Participant

    Hi,

     

    any tip for setting the 2 bearings on each side of the (X) Z axis that should slide on the rods ?

    I can’t manage to have them colinear/parallel so can’t install them correctly…

    #45752

    Ryan
    Keymaster

    Which ones? Can you take a picture or link to one from the instructions.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.