Turn off port P4 after connection power or reset

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Turn off port P4 after connection power or reset

This topic contains 0 replies, has 1 voice, and was last updated by Profile photo of Koen Koen 1 month, 1 week ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #30055
    Profile photo of Koen
    Koen
    Participant

    When I turn on the power for the MPCNC (with a Co2 laser) it turns on the laser, ….
    Where do I change the firmware that port P4 is turned off when powering it up?

    I use this board: MKS Gen 1.4
    See image for the port (name Servos2) if im right this are the aux ports.
    (#define SERVO3_PIN 49 // AUX3-3)

    But then 🙂

    • This topic was modified 1 month, 1 week ago by Profile photo of Koen Koen.
    Attachments:
Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.