Ug. 20%

This topic contains 2 replies, has 2 voices, and was last updated by  Mike 1 year, 1 month ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #16412

    Mike
    Participant

    Well, I was a dork. At the end of an 8 hour print, I realized I had infill set to 20%. Are any of these usable or do I need to scrap them all and lose a night’s printing?

    Top_Corner
    TopM_Corner
    Spacer
    Nut Trap
    Pineapple coupler

    #16414

    Barry
    Participant

    Spacer, nut trap and coupler are probably alright. The top pieces really don’t hold any weight, so they might be alright as well. Not sure how the torque of the belts will affect them though. I’d run with it and see what happens. Beef up your load bearing parts though, 20% really is too light. What kind of plastic are you using?

    #16416

    Mike
    Participant

    Oh, that’s good to hear. The top corners look pretty simple to swap after the fact if the thing starts racking.

    I’m using PLA. Everything else has been printed at 60% so far.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.