Vinyl Cutting

This topic contains 2 replies, has 2 voices, and was last updated by Profile photo of Jason Jason 7 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #16691
    Profile photo of Jason
    Jason
    Participant

    I was a little curious about vinyl cutting… Just ordered a holder and 15 blades.

    It is done basically the same way with estlcam and a pen? Except you make a cut on the outside and inside of a line instead of down then middle.

    Vinyl cutting doesnt seem to be discussed on here much so I wanted to start a little convo about it.

    #16694
    Profile photo of Curt
    Curt
    Participant

    I started a thread a few months ago asking about a drag knife. drag knife

    I just found a good looking one to print from thingiverse and ordered bearings yesterday. I will see how well it will work.

    #16696
    Profile photo of Jason
    Jason
    Participant

    Does it fit the 525 update z axis?

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.