Wire management – roller chain

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Wire management – roller chain

This topic contains 1 reply, has 2 voices, and was last updated by  alexpewpew 2 years, 2 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #3316

    Curt
    Participant

    What is everyone using for wire management? I like the idea of the flexible cable tray/roller chain but I do not know the right one to use. Any advice?

    Curt

    #3338

    alexpewpew
    Participant

    here is a video of my current set up. Lots of room for improvement but you can see my wire management. I bought 3 of these planning on extending the x and y with the 3rd. My machine is 4 feet a side. I haven’t lengthen the chains yet.

    And these are the chains i bought http://www.amazon.com/gp/product/B005GIRT6O?psc=1&redirect=true&ref_=oh_aui_detailpage_o01_s02

    I could have 3d printed a drag chain but at 10 bucks i felt this was an ok cheat 🙂

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.